CTArchitect 10.1
- Voice channel could be blocked in certain rare conditions
- twice mandia fast after each other could result in not unrouting the port
- Sentmailtosupport is now configurable for smtp connection and in a thread
- Set correct CLI for outboundcalls when using CLI on List definition
- routing table group 0 can be used
- unlisten before releasecall as requested by dialogic support
- Keep alive was not working fully for the second telephony node
- routing max tries was at 512 which may need to be higher in certain conditions
- unroute port during clerical time in predictive mode
- optimize port selection in predictive dialing for agents on voip ports
- report listen in error still in conference to supervisor
- B/I/O port settings can be broken for hmp ip devices
- requires HWClient 10.1.0.9
- non memory parameter info can be broken
- Sip keep alive support
- route to the other channel failed due to state not on dial for ip (only stateout was)
- retry reset lines if first reset fails
- give error tone for listen in when call is still in conference
- Allow Stop listen in without call id
- no answer timeout could be set at 30 when not required
- Extra restriction check for external loc going offhook with a DID provided
- requires vcredist 2010SP1
- file socket cache between CTArchitect &HWClient
- inter HWClient connections on voip possible
- HMP on HWClient
- Sip on aculab
- Carrier table values ISDN VOIP MSI are automatically adjusted according to available channels